#Troubleshoot brother hl 2140 printer install
#Troubleshoot brother hl 2140 printer driver

It will be something like usb://Brother/HL-2270DW%20series?serial=D4N207646 Run sudo lpinfo -v | grep usb to get the device name of your printer.(author’s shameful note: if you’re not looking, I find it surprisingly easy to plug USB B into the ethernet jack) Plug in the printer, verify that it shows up using sudo lsusb or sudo dmesg.

#Troubleshoot brother hl 2140 printer install

Sudo apt-get update & sudo apt-get install lpr cups ghostscript git cmake libcups2-dev libcupsimage2-devĬd brlaser-6 & cmake. (Option 2, recommended) Install ‘brlaser’ from source.Sudo apt-get update & sudo apt-get install lpr cups ghostscript printer-driver-brlaser Then, install the print system and driver: This is because we need brlaser 6, not brlaser 4 from debian 10 buster (current stable release). (Option 1, not recommended) Upgrade to Debian 11 bullseye (current testing release).Log into your raspberry pi to run the following steps I have written a convenience tool for this step, but you can also find any number of standard guides. At the time of writing the latest version is 10 (buster)–once 11+ is released this will be much easier. Get the latest raspbian image up and running on your pi, with working networking.brlaser 6, follow full steps below: DCP-L2520D series, DCP-L2520DW series, DCP-L2540DW series (unclear, may only need 4), HL-2030 series, HL-2140 series, HL-2220 series, HL-2270DW series, HL-5030 seriesĪlso, all these steps are command-line based, and you can do the whole setup headless (no monitor or keyboard) using SSH.

#Troubleshoot brother hl 2140 printer driver

The brother-provided driver does not run on arm processors like the raspberry pi, so we will instead use the open-source brlaser.Įdit: This setup should also work on the following Brother monochrome printers, just substitute the name where needed: Although the below directions work on Raspberry Pi, they should also work on any other system.